Installation Information

LOW-RIDER
The LOW RIDER console has a unique built-in feature allowing it to fit a variety of transmission tunnel shapes and sizes, including flat floor designs. Utilizing two pre-installed, non-slip, adjustable panels this console will rest securely on any transmission tunnel between the edge of a bench seat and the dash (or firewall). pre-installed non-slip, adjustable mounting system on the bottom of the console that can easily be shaped by hand to match the contour of the floor or transmission tunnel. No permanent alterations or tools needed.

– For flat floor installations, simply unscrew the Adjustable Mounting System on the bottom of the console OR the adjustable panels can easily be flattened by hand, depending upon your preference. Then place the console on the floor.

– For contoured floors or floors with a transmission tunnel simply bend and shape the adjustable panels by hand to customize the fit around the tunnel. Adjust the panels as needed to achieve a custom fit.

MODEL-A VAGABOND CONSOLE
Installation is fast and easy WITH NO PERMANENT alterations or tools needed. Simply unscrew the gear shift knob, and slide the integrated shifter boot over and down the manual shifter until it rests on the flat floorboard of the roadster. The Vagabond is multi-directional allowing the drink holders to be in front of or behind the shifter.

63-66 CORVETTE BULLET CONSOLE
Our Console rests on top of the factory console and is specifically designed with tall sides that slide down between the bucket seats and transmission tunnel.

HUMPHUGGER CONSOLE INSTALLATION
The Humphugger, as the name states, securely rests on the transmission tunnel (the Hump). The bottom is contoured to accommodate vehicle specific transmission tunnels, built-in Velcro on the bottom provides additional stability. Simply set the HumpHugger on the carpeted transmission tunnel and you’re ready to cruise! Installation is fast and easy with no tools needed OR permanent changes to your interior.

SADDLE CONSOLE INSTALLATION
Saddle consoles fit securely over the factory-installed (OE) console, between factory bucket seats. Installation is fast and simple. Place the console over top of the factory console and just slide it forward! Our Console is designed to fit snug over the factory console.

HUMPHUGGER CRUISER CONSOLE
Rest on Transmission hump between bucket seats, maneuvering the car’s shifter through shifter plate opening while lowering the front portion of the console.

SADDLE CRUISER CONSOLE
Full-length Console that fits over Factory console. Place saddle cruiser console over the rear portion of your factory console, lower into place and fit shifter through shifter plate opening while lowering the front portion of the console.

CORVAIR CONSOLE

The Corvair HumpHugger console fits securely over the carpeted transmission tunnel (the Hump) between factory bucket seats, using its velcro bottom to attach and hold itself in place.

  • Because the Corvair bucket seats are relatively close together, sometimes it’s easier to slide the console in place from the rear of the bucket seats moving the console forward to your desired position.

BC-CRUISER AND BD-DRINKSTER BENCH SEAT CONSOLES
Place the console anywhere on the bench seat that works best for you. For additional stability, a nylon strap is included, wrap it behind and under the seat, loop it through the buckle at the front of the console and cinch down for a firm hold.